03-22-2007, 06:33 PM
|
|
Senior Member
|
|
Join Date: Dec 2006
Location: Suffolk, Va.
Posts: 972
|
|
Re: Holes in transom
Quote:
|
Originally Posted by macojoe
Do as stated above with the dowle and glass, Just tap the dowle in about 1/3 inch and inish with formula 27 to match the gel coat a little. Its going to be covered by the motor anyway.
I also would drill a couple of 1/4 holes from the inside out to check the wood in the transom, just to make sure you have good wood! then just fill the small holes with 5200 be fine.
|
Ha, you said good wood!
|