Finally...the day came.
Okayyyy, I hope I didn't screw up here, I cut up a section of the VRO intake hose and stuck a SS 5/16 bolt and clamped it.
Here's the motor:
( don't know what is that bottle doing in my boat!!! ;D)
A bit closer:
Side view:
Oh and I also installed my new Racor filter:
I removed the holding tank and cut the two wires leading to the motor, tomorrow I'll run it with the 50:1 pre-mixed.
Should I remove the whole wire harness, or just jump the end so there's no alarm goning off?
Thanks :)
Joe