[regidog]

I was told the engine was rebuilt 60 hrs ago, outdrive is a fresh rebuild, trailer is in good shape. The work doesn't scare me and I've worked with fiberglass but not on structural areas like stringers and transoms.

My plan is to remove the deck, flip it over, and cut off the fiberglass from underneith. replace all the 1/4 plywood than refiberglass.

The rear floor I am going to cut out and gain access to the stringers to assess the damage. At this point I think its only bad at the connection to the transom. That could change very quickly.

The transom was reworked from the inside once already so I figure I will remove it from the inside as well. At this point I figure I am on a full restortion basis. I really like this boat so it will take time and patience and some good advice.

First thing I want to do is get the engine running so I can pull it and know I go that taken care of.

Seem like a good plan??