Re: Outboard Motor Stand
WTG rap, we should start calling you Bill Gates now :D
Stand looks very good, nice job. Is there any flex on the 2x6's with the motor hangin'? Not to criticize your work but one thing I may have done different would be to have swapped the 4x6's with the 2x6's. The main weight load is right where the 4x6's are sitting on the 2x6's. The 2x6's on end (vertical) would be plenty strong and the 4x6's on the flat would carry the load better. If there's no flex it shouldn't be a problem, just an observation. ;)
|