[willy]

I had made a replacement sea wall/shroud/bait table for my Robalo 1820 I just sold out of Star Board. It was meant to keep some of the water I used to get from coming onto the floor while drifting and it did it well. But I noticed a big benefit from it was how much it cut down on the noise from the 150 Merc. On that boat the motor was 4-5 feet behind you at most. I put four scuppers in the bottom and attached it permanently where the factory sea wall ( short, not water tight) was at and made a removable taller section with a bait table on it I would take off when trailering so I could tilt the engine all the way up