Quote:
Originally Posted by SkunkBoat
nice work 
Interesting the different models of V20s. Yours had a full transom and it was flat all the way across. My 84 cuddy had a motor well and the transom angled from the sides. it was actually 3 pieces of plywood.
I was concerned when I first saw your post that you didn't consider that but I can see in the pix its OK. If I used a flat transom on mine the cap and motor well would not have fit when they went back on. |
Thanks Skunk,
Oh mine is curved by a lot. It was original with a seadrive and has a small flat spot in the center. The only way I could match the curve was using the plywood on the outside and drew the inside plywood one at a time. When I bolted them in I used metal flat bars vertically.
The photo attached is looking down in the middle of the transom.