Quote:
Originally Posted by spareparts
remember also, you need lift, not necessarily set back, although set back requires less lift(rule of thumb is 2 inches set back covers one inch lift), I made a lift only bracket for a 70 by using two pieces of angle aluminum, I used the original mounting holes in the transom to mount the aluminum angle use flat head bolts so they fit flush), and drilled new holes thru the angle and transom for the engine mounting bolts. The top bolts were not supported by the transom, they only went thru the angle, the bottom bolts went thru the angle and hte transom
|
sorry, I did word that screwed up, Smoke explained it better than I did, you get the idea. The further you go back, the higher you can run the engine