Quote:
Originally Posted by jasoncooperpcola
Very good point. Heck i would just set the bottom on some 2x? lumber laid flat. My V20 is on a cinder block topped with a 2x6 in the rear and a stack 3 cinder blocks high up front so it drains. I can step right into the splashwell at that height. Of course this is just for bottom paint stripping. (yeah i know its been three months) Once i get ready to remove the liner for the bracket build, it will be in the garage on 6x6s.
Dont cut your floor. Just pop the cap. In my opinion its easier to pop the cap then repair the floor.
|
That is what I hear its easier to remove the cap. The problem is I am not sure how I am going to put the cap back on afterwards. I might have to rent one of those really big fork lifts??
I have the 4x4's in the ground. I'll snap a photo tomorrow. As going low to the ground. I am not sure how easy it would be without using a large forklift or tractor with a loader or backhoe. Thats another 300 to rent i'm sure.