Both Guns shown are quite the opposite in regards to what you will be using it for. If the paint is thinned and good atomization is desire for a clean and smooth finish the first gun is your choice. Its what I used to finished my Cowling.
If its heavy or thick two part epoxy or polyurethane paint then the gravity HVLP is your best bet. Its what I used to shoot Gel Coat on my Hull.
I will highly recommend you buy your paint first and test on a scrap material. Be sure to test at various pot pressure etc.
I personally own both el cheapo guns shown, I however must mentioned also they are my favorite over my very expensive collections.
Please pay attention to the tip size in your selection process
Bare in mind I am the Guy who can't get paint to dry. See my Engine project in another thread :)
|