[nymack66]

I did my transom using Arjay its not difficult at all you can do it, I did cut the outer skin off because the wood was not completely rotten and would have been a PIA to remove. One of the most important step before pouring the arjay is to seal every pin hole since this stuff will seep through during the pour.
Be sure to re-enforce the inside of both walls with cloth and resin to an extent you KNOW it stronger than before. The inside skin after cleaning was very thin and huge holes could be seen as shown in the pictures
I cut down my transom to 20" from a 25" note I also lower the drain hole so it never lodges water in the bilge area.




























Skin Back on !









Home run ?

































At last !!



Engines On


No Cap nice and clean