This was my reply to another person asking the same info:
We just disconected and labled all the wires that run through th floor to the CC. Disconnected the steering and throttle cables and then removed the CC. You will also need to disconect any gas lines and lighting wires that will be an issue. We then removed the motor and rub rail. Under the rub rail you will find all the screws that hold the two sections together and they need to be removed. We then hooked a rope to the upper deck and rigged a pulley up in a big tree limb and down to my buddies truck. We also went around and popped the two sections apart as they had been caulked together. He just then started to raise the inner section as I watched for any other things that may be connected. After it was high enough to clear the hull we pushed the trailer and hull out of the way and lowerd it back down. One thing to remember is to make sure you use a branch strong enough to hold the weight as that was our first mistake. LOL You then have access to the transom, flooring and you can inspect stringers. Taking the boat apart only took us one weekend but your boat is a different year so all this could be totaly wrong for your boat. I also replaced most of the wiring at the same time but my boat had sunk and need new wires. If your thinking about doing this and would like to talk PM me your # and I'll give you a call.
|