[THEFERMANATOR]

Originally Posted by skintraditions

yea i pulled the vin of the motor and its a 235 ,i dont have the money to buy another motor so will the 235 work on this boat ? or do i need to just sell this one and get a 150 ? whats the waight difrence on the 235 and the 150

The 235 was built up until 85, and in 86 it became the EVINRUDE XP which was a strong 175HP at the prop(real close to 200). The weight difference between the 150 and 235 is negligeable, maybe 10 pounds difference due to the bubble back exhaust and such. Just keep in mind that the 235HP will have enough HP to tear the transom off if you have it propped with an aggressive prop and loaded down. The older cross-flow engines make the majority of there power down low and have strong grunt to em getting on plane. Also watch your WOT RPM's, at 5750 the flywheels on the cross-flows are known to explode and become some VERY dangerous projectiles, 5500 is the max you want to turn it stock. I would set the throttle stop on the engine to a bit over half throttle and just run it easy.