Quote:
Originally Posted by MIKETTURBO
changed my trim motor today,1 bolt broke & i had to drill & tap.then i changed the water pump.JONNY 175. & 1 bolt broke,theres about 3/16 of the bolt sticking out.i tried heat & visegrips no good.i'am trying so soak it in oil overnight.any suggestions? i hate drilling & tapping.
|
The EZ-Out method usually leads to a real mess on metal that's been around salt water, don't get trapped by that one. I like the "left hand drill bit" if you can get it centered well and have a steady hand. The flutes are reversed and the drill is run in reverse. When enough of the bolt is removed, it will typicall spin out stuck as the drill grabs. Just use the proper tap size drill and it will cut out enough of the bolt out to allow it to free up. I've also welded a hex nut to the protruding broken bolt and used a wrench to remove. The heat from arc welding helps break the frozen bolt loose too. Either one takes a steady hand.