[fillet1]

Thanks.

I am dying to get the cover off completely so that I can do some gel coat repair and fill the screw holes. I'll probably have to wait until it warms up to get to it, or the gel/filler/ epoxy wont cure properly.

I still have lots to do. Right now my short list is:

1. Clean up the wiring in the cabin - There is no cover for the rear of the helm, and the wiring, while new, is a mess. Plus, the running lights were re-wired by the p.o. and the wires just drop down onto the "shelf" inside the cabin. I dont really know what to do with that yet. Apparently the old wire was under the carpet??

2. Make a cover for the well in the cuddy. - probably out of marine ply.

3. Fix/re-route raw water washdown system.