Thread: V2o Steplift
View Single Post
  #5  
Unread 05-07-2008, 10:12 PM
nymack66 nymack66 is offline
God
  
Join Date: Jul 2007
Location: Orlando Florida
Posts: 1,069
Send a message via ICQ to nymack66
Default Question
Can I mount Evinrude 140 20" shaft on this hull , Its a 1984 v20 Steplift the transom seems to be higher than my 83 v20 Steplift by approximately three inches , Or can I use a Jack Plate , I have seen some pros mentioned "Jack Plates was not meant to compensate a short shaft motor"
Attached Images
File Type: jpg 1984 Wellcraft V20.JPG (75.4 KB, 67 views)
Reply With Quote