Forum: Modifications
06-24-2012, 06:28 PM
|
|
Replies: 26
Views: 1,715
|
|
Forum: Modifications
03-25-2012, 04:09 PM
|
|
Replies: 26
Views: 1,715
|
|
Forum: Repairs
12-21-2011, 09:28 AM
|
|
Replies: 16
Views: 2,274
geekie1 i am trying to replace my aluminum fuel...
geekie1 i am trying to replace my aluminum fuel tank in my 84 fisherman centerconsole and am trying to find a suitable aftermarket PLASTIC tank only. is there one you have discovered that is close...
|
|
Forum: Repairs
11-29-2011, 06:25 PM
|
|
Replies: 0
Views: 216
|
|
Forum: General
11-28-2011, 05:33 PM
|
|
Replies: 11
Views: 666
1984 fisherman centerconsole fuel tank? moeller
ok i pulled the old rotted aluminum 60 gallon fuel tank out of the 1984 fisherman center console . my next question is will the moeller 55 gallon tank fit? has anyone used one of these tanks in the...
|
|
Forum: Repairs
11-27-2011, 04:11 PM
|
|
Replies: 16
Views: 2,274
1984 center console dimensions different?
just thought i 'd tell you that my 1984 center console fisherman 60 gallon tank dimensions are completely different from the 1985 one that is depicted sooo just be sure before you order your tank!!! ...
|
|
Forum: Repairs
10-15-2011, 07:50 AM
|
|
Replies: 16
Views: 1,052
|
|
Forum: Repairs
09-05-2011, 04:39 PM
|
|
Replies: 11
Views: 351
|
|
Forum: Modifications
09-04-2011, 09:19 PM
|
|
Replies: 26
Views: 1,715
ridge runner tell us how you cut the aft...
ridge runner tell us how you cut the aft fishbox/well out on your center console. i think i will do the same soon. is there any structural issues if the bottom is removed? does it need to be...
|
|
Forum: Repairs
09-02-2011, 10:06 AM
|
|
Replies: 11
Views: 351
|
|
Forum: Repairs
09-02-2011, 07:33 AM
|
|
Replies: 11
Views: 351
ok now the plot thickens. i do leave it in salt...
ok now the plot thickens. i do leave it in salt water in a slip. so it should be attached to engine mounting bolt,( or if you have a threaded drain plug, to one of the screws holding the drain plug...
|
|
Forum: Repairs
09-02-2011, 07:04 AM
|
|
Replies: 11
Views: 351
the wire was run to the back of the boat in the...
the wire was run to the back of the boat in the bilge. i wonder if they connected it at one time to the neg terminal of the battery. it sounds like it would be better to connect it to the Negative...
|
|
Forum: Modifications
09-01-2011, 08:25 PM
|
|
Replies: 26
Views: 1,715
|
|
Forum: Repairs
09-01-2011, 08:01 PM
|
|
Replies: 11
Views: 351
|
|
Forum: Modifications
04-19-2010, 12:02 PM
|
|
Replies: 12
Views: 777
jackplate on / jacking nuts loosen up?
i installed it last week, and will test next week wx permitting. i had to reroute the manual steering cable thru another hole which was drilled a little higher in the back. it went thru but was not...
|
|
Forum: Repairs
03-28-2010, 05:53 PM
|
|
Replies: 1
Views: 213
removing outboard from transom? tips
trying to pull a 150 HP outboard from the transom but it seems stuck with what looks like 3M 5200. will it be necessary to pull the 4 bolts as well to remove the outboard? any tips?
|
|
Forum: Modifications
03-03-2010, 05:25 PM
|
|
Replies: 12
Views: 777
i will have to look later, the boat is 30 miles...
i will have to look later, the boat is 30 miles away sleeping for the winter. the yamaha is a 2001 HPDI 150 HP 2 stroke, model number is z150tlrz on a 1984 20' fisherman center console. i guess it...
|
|
Forum: Modifications
03-03-2010, 04:11 PM
|
|
Replies: 12
Views: 777
|
|
Forum: Modifications
03-03-2010, 08:53 AM
|
|
Replies: 12
Views: 777
notched transom OR jackplate ?
Ok i have a 1984 20 Fisherman with a 2001 150 hpdi yamaha currently installed on a 20" notched transom . I wanted to raise the motor with a manual CMC jackplate but it looks like i may have steering...
|
|
Forum: Performance
03-02-2010, 09:47 PM
|
|
Replies: 4
Views: 574
Notch improvement or jackplate???
tsubaki did you fill the notch on your boat? I've been looking to install a cmc jackplate but i've noticed that my steering system may get in the way and bind if i move the motor back and up with the...
|
|
Forum: Performance
10-30-2009, 09:01 PM
|
|
Replies: 4
Views: 574
|
|
Forum: Modifications
08-28-2009, 10:39 AM
|
|
Replies: 4
Views: 342
battery relocation on 84 fisherman to c/c ?
i'm considering relocating my single 12 volt battery fromm the rear bilge area to the someplace in the center console area on my 1984 fisherman. i would like to reduce the weight in the stern. Has...
|
|
Forum: Repairs
05-27-2009, 04:24 PM
|
|
Replies: 19
Views: 784
|
|
Forum: Repairs
05-26-2009, 08:35 AM
|
|
Replies: 19
Views: 784
whats the best way to store gorilla glue. last...
whats the best way to store gorilla glue. last bottle i had cured in the bottle before i had a chance to use it. Is it something i should store in the fridge? to make it last longer between uses.
|
|
Forum: Repairs
05-25-2009, 07:40 PM
|
|
Replies: 19
Views: 784
|
