Wellcraft V20 Community

Go Back   Wellcraft V20 Community > Search Forums
Register FAQ Community Calendar Today's Posts Search

Showing results 1 to 25 of 500
Search took 0.33 seconds.
Search: Posts Made By: Kracker Jack
Forum: General 02-26-2020, 11:58 PM
Replies: 718
Views: 35,994
Posted By Kracker Jack
It has been a long time since I have been in...

It has been a long time since I have been in here!!! I hope everyone is doing well. A lot has happened in my life since this thread was started. Im getting ready to start a transom bracket thread on...
Forum: Repairs 04-24-2018, 09:21 AM
Replies: 7
Views: 172
Posted By Kracker Jack
I have the teleflexTFXtreme cables and they are...

I have the teleflexTFXtreme cables and they are smooth as glass. And will adapt to a tighter radius if it’s needed
Forum: Repairs 04-18-2018, 07:19 AM
Replies: 8
Views: 305
Posted By Kracker Jack
I aldo removed my floor from under my console for...

I aldo removed my floor from under my console for three reasons. To inspect stringers up forward, recess fuel tank in floor and repair small soft spot in my floor around my rigging tube that cracked...
Forum: Repairs 04-18-2018, 07:10 AM
Replies: 8
Views: 305
Posted By Kracker Jack
The first picture shows me pointing at the repair...

The first picture shows me pointing at the repair after I grinded a 50 inch void out of the bottom. I progressive lapped 1708 to build up repair area. The second picture show me pointing at the chine...
Forum: Repairs 04-18-2018, 07:05 AM
Replies: 8
Views: 305
Posted By Kracker Jack
Here’s more pictures of the repaired area and...

Here’s more pictures of the repaired area and keel that had factory void in it
Forum: Repairs 04-18-2018, 07:01 AM
Replies: 8
Views: 305
Posted By Kracker Jack
Repairing factory voids on bottom of my v20

As some of you might know I ran my v20 in from 30 miles offshore and took a serious butt whoopin over month ago. After inspecting my hull I noticed I had a 50 to 60 inch lateral type fracture/Delam...
Forum: Classifieds 04-18-2018, 06:28 AM
Replies: 15
Views: 1,032
Posted By Kracker Jack
Well I have really good news basically the damage...

Well I have really good news basically the damage was not from the stringer. The stringer and stringer pockets are solid as a rock. The delaminating wascaused by factory voids under the gelcoat and...
Forum: Classifieds 03-27-2018, 12:28 PM
Replies: 15
Views: 1,032
Posted By Kracker Jack
Yes brandnew 150 hp suzuki

Yes brandnew 150 hp suzuki
Forum: Classifieds 03-22-2018, 03:09 PM
Replies: 15
Views: 1,032
Posted By Kracker Jack
I’m gonna de rig it mostly and flip it upside...

I’m gonna de rig it mostly and flip it upside down and do some repairs. It will be perfect for cruising the inter coastal,spec fishing in the inlet blah blah blah
Forum: Classifieds 03-21-2018, 05:51 PM
Replies: 15
Views: 1,032
Posted By Kracker Jack
My v20 hull might be forsale soon

Gentleman I never thought I would say this but my v20 might be going up forsale. Coming in from offshore 3 weeks ago rough as S$/t I took 10 really good shots on the hull and developed a lateral...
Forum: Modifications 11-28-2017, 10:32 PM
Replies: 17
Views: 1,306
Posted By Kracker Jack
Kevin I moved mine 6 to 8 inches forward from...

Kevin I moved mine 6 to 8 inches forward from factory. I wouldn't go any further forward than mine. They way mine is set up would really put you very close to where you wanna be.
Forum: Fishing 11-28-2017, 02:01 PM
Replies: 3
Views: 162
Posted By Kracker Jack
With my new 150 Zuk getting 3.8 to the gallon...

With my new 150 Zuk getting 3.8 to the gallon yesterday I would say it could be worse!!!!
Forum: Fishing 11-28-2017, 12:32 PM
Replies: 3
Views: 162
Posted By Kracker Jack
Forum: Repairs 11-19-2017, 11:18 PM
Replies: 10
Views: 389
Posted By Kracker Jack
Definitely do what's stated here (coat raw core...

Definitely do what's stated here (coat raw core material with epoxy or a reduced resin) then fill with 5200 and clam shell over hole.
Forum: Performance 11-07-2017, 08:48 PM
Replies: 40
Views: 1,502
Posted By Kracker Jack
Yea but they only have to run 2 miles off the...

Yea but they only have to run 2 miles off the beach to be in the pelagics!! Lol!!!
Forum: General 10-07-2017, 02:47 PM
Replies: 9
Views: 438
Posted By Kracker Jack
Listen to him!!!! Just put tabs on my v24.....I...

Listen to him!!!! Just put tabs on my v24.....I mean v20. Seriously the boat rides like it grew 4 feet with the trim tabs on it!
Forum: Tackle and Gear 10-07-2017, 02:35 PM
Replies: 17
Views: 824
Posted By Kracker Jack
They are the backbone to my offshore rods. These...

They are the backbone to my offshore rods. These reels are USA made ranging from early to late 70's 100% rebuilt. They were my dads reels when I offshore bluefin and yellowfin tuna fished with him on...
Forum: Performance 09-06-2017, 06:28 PM
Replies: 11
Views: 738
Posted By Kracker Jack
Used the new lencos on Monday. Went with the 9x12...

Used the new lencos on Monday. Went with the 9x12 feels like I added 4 ft to the length of the boat. Very nice add on
Forum: Classifieds 08-21-2017, 07:33 AM
Replies: 3
Views: 264
Posted By Kracker Jack
I'm not sure I will check

I'm not sure I will check
Forum: Classifieds 07-26-2017, 08:17 AM
Replies: 3
Views: 264
Posted By Kracker Jack
2002 Suzuki df140 non running parts motor

My old 140 is forsale loaded with new parts.....clean with minimal corrosion. 800 dollars with prop. Motor is non running it dropped timing and spit some gears
Forum: General 07-25-2017, 08:48 PM
Replies: 718
Views: 35,994
Posted By Kracker Jack
This wing panel unzips from the side/gunwale...

This wing panel unzips from the side/gunwale panels then you unclip from gunwale and walk thru.
Forum: General 07-25-2017, 08:44 PM
Replies: 718
Views: 35,994
Posted By Kracker Jack
Des here is my summer set up. It consist of 3...

Des here is my summer set up. It consist of 3 panels...the front panel and 2 side wing panels. The side wing panels can either clip to the console creating a dog house style set up of they can clip...
Forum: General 07-24-2017, 08:23 PM
Replies: 718
Views: 35,994
Posted By Kracker Jack
The new motor is off the freaking charts. She...

The new motor is off the freaking charts. She screams!
Forum: General 07-24-2017, 08:18 PM
Replies: 718
Views: 35,994
Posted By Kracker Jack
More pics of the ole girl

More pics of the ole girl
Forum: General 07-24-2017, 08:16 PM
Replies: 718
Views: 35,994
Posted By Kracker Jack
Curtains are finished. Put a lot of money in this...

Curtains are finished. Put a lot of money in this boat past couple weeks but she is looking good!
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 03:07 PM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.