Forum: General
12-28-2021, 11:54 AM
|
|
Replies: 3
Views: 203
|
|
Forum: Repairs
06-28-2021, 07:36 PM
|
|
Replies: 34
Views: 1,046
|
|
Forum: Repairs
06-28-2021, 07:22 PM
|
|
Replies: 7
Views: 402
great job i was wondering what you use to fill...
great job i was wondering what you use to fill the void between the inner transom skin and outer skin? the transom is three pieces of plywood with the outer pieces at a angle from center piece....
|
|
Forum: Repairs
10-07-2020, 06:47 PM
|
|
Replies: 25
Views: 1,273
|
|
Forum: Performance
07-29-2020, 08:15 PM
|
|
Replies: 2
Views: 237
|
|
Forum: Performance
07-29-2020, 08:51 AM
|
|
Replies: 2
Views: 237
Evinrude 225 carb numbers
Good morning,
Hope all is well,
Looking for information on carburetor part numbers for a evinrude E225cxeud. I am told 0439188 and 0439189 will work ?
I find these number on boat.net website....
|
|
Forum: Repairs
04-27-2019, 06:20 AM
|
|
Replies: 25
Views: 1,273
Well, I finally got the motor well out last...
Well, I finally got the motor well out last night, it was a bear. I had to cut out one of the bait hatches out just to get it to move forward and use a multifunction tool to cut out the bottom of the...
|
|
Forum: Repairs
04-26-2019, 10:08 AM
|
|
Replies: 25
Views: 1,273
|
|
Forum: Repairs
04-25-2019, 07:43 PM
|
|
Replies: 25
Views: 1,273
|
|
Forum: Repairs
03-11-2019, 01:41 PM
|
|
Replies: 25
Views: 1,273
Well I did a few videos on my water damaged...
Well I did a few videos on my water damaged transom, using the hammer, drill, and moisture meter. It is showing sighs of water damage near top of motor well area , topside near rear of both storage...
|
|
Forum: Repairs
01-24-2019, 05:10 AM
|
|
Replies: 25
Views: 1,273
thanks everyone , will look into skunkwork's...
thanks everyone , will look into skunkwork's method, i seen that a few times on you tube. and trying to see what materials i will need. boats in storage, will do thump check when i get over there....
|
|
Forum: Repairs
01-22-2019, 06:38 PM
|
|
Replies: 25
Views: 1,273
|
|
Forum: Repairs
01-18-2019, 09:19 PM
|
|
Replies: 25
Views: 1,273
Transom repair???
well, as i was installing my Lenco trim tabs, to the transom of my 86 v20 cc, brown water came out of the drill holes. When i purchased the boat i did check for flexing on the transom, and when i...
|
|
Forum: Modifications
11-06-2018, 04:34 PM
|
|
Replies: 5
Views: 386
|
|
Forum: Modifications
10-27-2018, 07:24 PM
|
|
Replies: 5
Views: 386
|
|
Forum: Modifications
10-22-2018, 08:27 PM
|
|
Replies: 5
Views: 386
hydraulic steering helm installation
hello
I am installing a telestar hyd steering for my 86 v20 with a Evinrude 225. I notice the helm pump requires a smaller hole (3 in) and has a four bolt pattern. (PHOTOS INCLUDED) I was wondering...
|
|
Forum: Gallery
01-03-2018, 09:14 AM
|
|
Replies: 90
Views: 6,834
|
|
Forum: General
01-02-2018, 10:17 PM
|
|
Replies: 16
Views: 843
|
|
Forum: Repairs
12-23-2017, 10:07 PM
|
|
Replies: 4
Views: 245
|
|
Forum: Repairs
12-22-2017, 02:15 AM
|
|
Replies: 4
Views: 245
bilge pump placement on 86 v20 c/c
hello
i was wondering if anyone knows for sure if the floorboard area in front of the drain hole in the bilge area is suitable for screwing down a bilge pump. it feels solid, but i want to make...
|
|
Forum: Repairs
12-15-2017, 07:31 PM
|
|
Replies: 9
Views: 527
|
|
Forum: Repairs
11-11-2017, 09:29 PM
|
|
Replies: 2
Views: 251
|
|
Forum: Repairs
11-03-2017, 09:49 PM
|
|
Replies: 2
Views: 251
repaired fuel tank and live bait hatch lid.
i replaced the plywood under the lids with 3/4 in marine plywood, and fiberglass it with 1.5 matted fiberglass. followed by a layer of 1078.
my question is should it be just painted or a gelcoat...
|
|
Forum: Repairs
11-03-2017, 09:23 PM
|
|
Replies: 10
Views: 569
|
|
Forum: Repairs
11-03-2017, 09:18 PM
|
|
Replies: 10
Views: 569
|
