Wellcraft V20 Community

Go Back   Wellcraft V20 Community > Search Forums
Register FAQ Community Calendar Today's Posts Search

Showing results 1 to 25 of 49
Search took 0.02 seconds.
Search: Posts Made By: Starzofchaos
Forum: Modifications 06-12-2016, 08:55 AM
Replies: 1
Views: 237
Posted By Starzofchaos
Post Quantum Paints

I talked to a boat builder today about paints. He now only uses quantum paints by Engineered Marine Coatings Inc. Anyone use this paint? He told me he used to only use awlgrip, but after a demo and...
Forum: Performance 02-21-2016, 08:08 AM
Replies: 1
Views: 226
Posted By Starzofchaos
Something like this would be fine.......

Something like this would be fine.... https://www.batterystuff.com/battery-chargers/12-volt/marine-chargers/RS2.html

Its a 6amp per bank 2 bank charger. It will do the full 6 amp charge till full...
Forum: Performance 02-21-2016, 07:40 AM
Replies: 13
Views: 756
Posted By Starzofchaos
I was told when they tune their motors SAE allows...

I was told when they tune their motors SAE allows a difference of +- 10% hp than what is rated for. Its been proven with most motor manufactures that they all produce hp in the +10% range. So 10% of...
Forum: Performance 02-21-2016, 07:20 AM
Replies: 20
Views: 1,223
Posted By Starzofchaos
The guy that recovered my bunks used something...

The guy that recovered my bunks used something like this stuff...
http://www.gatorbak.com/

http://www.astroplastics.com/astro_slip.htm (http://www.gatorbak.com/)

Not sure if its it, but he...
Forum: General 02-13-2016, 03:08 PM
Replies: 8
Views: 339
Posted By Starzofchaos
Thumbs up Just my observation, most manufactures prefer...

Just my observation, most manufactures prefer lenco tabs. One guy told me its due to the compact design, no hydraulic pumps, etc... They even offer a bennett retro fit kit. A couple of years ago,...
Forum: Repairs 01-31-2016, 11:27 AM
Replies: 21
Views: 953
Posted By Starzofchaos
If you are looking to replace the teak in your...

If you are looking to replace the teak in your rod boxes, you can always have some one cut you a new piece out of starboard. There are a few people on the internet that can. Honestly, as long as the...
Forum: Repairs 12-24-2015, 11:56 AM
Replies: 8
Views: 417
Posted By Starzofchaos
Post I had a cap off restoration done on my 1990 18'...

I had a cap off restoration done on my 1990 18' Wellcraft Fish. The reason my Transom rotted out was due to a poor final finish at the factory. It is where the transom meets the sides of the boat....
Forum: Links 11-18-2015, 03:29 PM
Replies: 3
Views: 1,641
Posted By Starzofchaos
Exclamation No Longer in Business! =(

No Longer in Business! =(
Forum: Performance 06-22-2015, 12:46 PM
Replies: 12
Views: 590
Posted By Starzofchaos
Try this guy, located in Tampa: Franzen Marine......

Try this guy, located in Tampa: Franzen Marine... Give him a call first and see what he has v.s. the ebay site. I've spoken to him before, those on the ebay site are his top notch used motors that he...
Forum: Classifieds 04-18-2015, 07:21 AM
Replies: 39
Views: 1,355
Posted By Starzofchaos
Give this guy a call... ...

Give this guy a call...
http://vikingmarineservices.homestead.com/index.html

I talked to him the other day, he overhauls motors and has some used ones. Most are carb 2 two strokes.

Or you...
Forum: Repairs 04-16-2015, 06:10 PM
Replies: 10
Views: 432
Posted By Starzofchaos
Please make sure that the strips are not rubber....

Please make sure that the strips are not rubber. Rubber will corrode the Aluminum.

http://marinesurvey.com/yacht/fueltank.htm

Suggestion is to glue some plastic strips where the wood will make...
Forum: Links 04-16-2015, 08:38 AM
Replies: 0
Views: 367
Posted By Starzofchaos
Thumbs up Custom Switch Panels

Had a custom switch panel made up from this place. Fair prices and top notch work! He even did the pre-wire and added a bus bar on the switch panel with out charging more!
...
Forum: Links 04-16-2015, 07:56 AM
Replies: 3
Views: 1,641
Posted By Starzofchaos
Thumbs up Florida Marine Plastics

Found this guy while trying to find someone whom makes custom King Starboard hatches with out charging a massive amount of money. Good work as well!

http://www.flmarineplastics.com/
Forum: Repairs 04-15-2015, 08:23 AM
Replies: 23
Views: 927
Posted By Starzofchaos
I wouldn't doubt it.... I know a few people that...

I wouldn't doubt it.... I know a few people that has done some testing and found that it says E-10 on the pumps, in fact tested to around E-15... I know people that race go-karts and high performance...
Forum: General 04-15-2015, 08:07 AM
Replies: 15
Views: 693
Posted By Starzofchaos
Question Your Evinrude E-Tech experience

Well I wanted to start a thread on your overall satisfaction with your Evinrude E-Techs and warranty issues. The reason that I ask, is while attending a boat show here in Jacksonville this past...
Forum: Repairs 04-13-2015, 03:18 PM
Replies: 23
Views: 927
Posted By Starzofchaos
Ethanol gas is fine if you run it in what you use...

Ethanol gas is fine if you run it in what you use every day. Now when the problems you run into is if you let it set around for too long. Ethanol gas just after two weeks starts to develop what is...
Forum: General 04-13-2015, 08:29 AM
Replies: 6
Views: 309
Posted By Starzofchaos
Actually I have used Defender Marine for hoses....

Actually I have used Defender Marine for hoses. Or at least compare the prices.

http://www.defender.com/category.jsp?path=-1|2243574&id=2243581

Also if you are going that route and putting in...
Forum: Fishing 03-28-2015, 03:09 PM
Replies: 8
Views: 292
Posted By Starzofchaos
Ya I've been lucky to catch one inshore while...

Ya I've been lucky to catch one inshore while throwing a spoon for trout. Thought it was a trout at first, then while I was trowing him back noticed the hard tail. I think that was early last April...
Forum: General 03-12-2015, 07:48 PM
Replies: 52
Views: 1,606
Posted By Starzofchaos
I also second on the K.I.S.S method... I've got a...

I also second on the K.I.S.S method... I've got a complete re-wire project coming up on mine. I've got a few plans to run a dual battery system with a Automatic Charging Relay installed between the...
Forum: General 03-12-2015, 07:26 PM
Replies: 31
Views: 1,526
Posted By Starzofchaos
Yes, Marine AB plywood is Douglas Fir. Not sure...

Yes, Marine AB plywood is Douglas Fir. Not sure what the Big Box stores carry. Doing a quick search says you can even get marine ply wood at these places.
http://www.roseburg.com/Product/abmarine/...
Forum: Repairs 03-08-2015, 03:52 PM
Replies: 9
Views: 558
Posted By Starzofchaos
Ya I am looking to get another 10 years or so out...

Ya I am looking to get another 10 years or so out of her. So I'll try to get it looking decent. The bottom coat is really bad and needs to be done. I am looking into doing a hard bottom type like...
Forum: Repairs 03-04-2015, 05:04 AM
Replies: 9
Views: 558
Posted By Starzofchaos
Now I am need of some help... I am looking in the...

Now I am need of some help... I am looking in the Northeast Florida area to get the bottom painted. The last owner tried to remove it by using a 60 or 80 grit sand paper, so its pretty scored. So the...
Forum: Repairs 03-04-2015, 05:01 AM
Replies: 9
Views: 558
Posted By Starzofchaos
Transom is fixed! Cap is installed and what came...

Transom is fixed! Cap is installed and what came off is now getting re-installed.

I had the inside cap painted with Awlgrip in Seattle Grey to cut the glare. While I was at it, I also had the...
Forum: Repairs 08-10-2014, 12:17 PM
Replies: 9
Views: 558
Posted By Starzofchaos
Basically to get at the transom and remove all of...

Basically to get at the transom and remove all of the rotted wood and inspect the stringers, they removed the cap.

http://i1210.photobucket.com/albums/cc416/starzofchaos/Wellcraft/DSC00207.jpg
...
Forum: Repairs 08-10-2014, 12:10 PM
Replies: 9
Views: 558
Posted By Starzofchaos
1990 Wellcraft Fish 18 Overhaul Thread

My dad and I both went halves on this 1990 Wellcraft Fish 18 a few years back, since then it has been sitting in his back yard for about two years waiting on me to come and rescue it. So I dragged it...
Showing results 1 to 25 of 49

 
Forum Jump

All times are GMT -5. The time now is 04:54 AM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.