Wellcraft V20 Community

Wellcraft V20 Community (https://forums.wmpdevserver1.com/community/index.php)
-   Performance (https://forums.wmpdevserver1.com/community/forumdisplay.php?f=15)
-   -   What temp I/O guys? (https://forums.wmpdevserver1.com/community/showthread.php?t=7433)

WiseGuy 06-18-2006 11:47 PM

What temp I/O guys?
 
Hey guys
What temp are you running on your engine. Think I'm high (temperature!) thought I'd poll you guys. What thermostat for a Merc 898?

Thanks
Pete

76GMC1500 06-19-2006 04:14 AM

Re: What temp I/O guys?
 
160-165 for raw water cooled and 160-195 for fresh water cooled. The hotter you can run it, the better. But, since raw water systens are non-pressurized, they cannot operate at 195 because there will be localized hotspots above the boiling temp of water at 212 degrees. At 16 psi with coolant, systems can operate as high as 270 degrees before boiling so fresh water systems can operate hotter.

rb437 06-20-2006 07:08 PM

Re: What temp I/O guys?
 
my fresh water cooled runs about 135 -140 in 75-80 deg water.

76GMC1500 06-20-2006 07:18 PM

Re: What temp I/O guys?
 
Rick, put a thermostat in your motor, you cylinders will thank you for it.

fishmaster63 06-25-2006 09:19 PM

Re: What temp I/O guys?
 
i have the 5.7/260 i/o. i just had it hooked to the earmuffs and it seemed to run pretty hot. i hope its just my water pressure and hoping it runs cooler when in the water.
comments?

rb437 06-26-2006 01:44 AM

Re: What temp I/O guys?
 
Thanks GMC, I'll try that. I thought it seemed a little cold.

macojoe 06-26-2006 10:39 AM

Re: What temp I/O guys?
 
should run all right on the muffs, but you can't race it or anything. But at Idle should be fine, at least mine was.

use to run 165 in it.


All times are GMT -5. The time now is 07:44 PM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.