Wellcraft V20 Community

Wellcraft V20 Community (https://forums.wmpdevserver1.com/community/index.php)
-   Modifications (https://forums.wmpdevserver1.com/community/forumdisplay.php?f=13)
-   -   guages (https://forums.wmpdevserver1.com/community/showthread.php?t=17152)

keepitgreen05 01-24-2012 11:11 PM

guages
 
can you use for example honda guages on a johnson motor

Destroyer 01-25-2012 12:56 AM

I believe you can use any guages on any engine. In the case of the Tach, you need to have the tack set for the same number of poles as the alternator poles. Other than that I cannot see any reason you can't use whatever type/brand you want. About the only one I can think of that you might have a problem with would be the tilt/trim guage, not sure how specific that is to the original ...:head:

spareparts 01-25-2012 08:11 AM

normally if its a standard type gauge, you can swap them around, but if its a manufacturer's branded gauge(especially the digital ones) you may run into issues

csvencer 01-26-2012 03:16 PM

Yes and no. I know the newer Johnson/Evinrude ones have a 8 pin pigtail and no regular posts. So are just feed, ground and light, so they are pretty universal. Also when you are talking Tachs, you need to know how many poles the gauge and the motor are.

-Svence

Kracker Jack 01-29-2012 10:00 PM

Im not trying to hijack this thread im also looking for advice on gauges. Lets say i was looking for a tach for my 78 evinrude 135hp. what should I look for?

Destroyer 01-30-2012 12:31 AM

Quote:

Originally Posted by Kracker Jack (Post 184703)
Im not trying to hijack this thread im also looking for advice on gauges. Lets say i was looking for a tach for my 78 evinrude 135hp. what should I look for?

Generally speaking, the instructions that come with a new tach will tell you what engine you can use it with (number of cylinders) and on the back of the tach will be a small dial that you will use to set it to the number of poles on your engine. (What you are actually setting the tach to is the number of poles on your alternator) Normally they will function with either 4, 8, 12, 14 or 16 poles on your rotor, depending on what your engine has. (The pulses can also be obtained from the ring gear of your engine by means of an electromagnetic sensor). By setting the dial on the back of the tach what you are actually doing is telling the tach how many pulses to count for one complete revolution of the engine. So, to answer your question, what you need to look for is how many poles are on the alternator of your 135. You should be able to find out that information from Evinrude's website or pretty much from any site that sells replacement alternators for your engine. Hope this helps.

bradford 01-30-2012 09:11 AM

Quote:

Originally Posted by Kracker Jack (Post 184703)
Im not trying to hijack this thread im also looking for advice on gauges. Lets say i was looking for a tach for my 78 evinrude 135hp. what should I look for?

Ferm or Skools would probably know.


All times are GMT -5. The time now is 12:00 PM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.