Under gunnel rod boxes
 

My plastic liners for the rods were cracked and crumbling apart. So I decide to build new ones. I trimmed off the edges of the old liner, and used the back. Then I made a box out of PVC tuff board. Never rots..or cracks. Epoxy filled in the holes, painted with Plastic Paint. Now it will get installed using finishing washers.

This is what it looked like. Very strong..the teak rod holders hold it in the middle very tightly. Originally they just hung from the plastic. Now they are drilled from top bottom and back.

http://farm5.static.flickr.com/4051/...835229aa84.jpg

Dry Fitted...

http://farm2.static.flickr.com/1288/...962de7f611.jpg

A little more finishing and they will be mounted in.

http://farm5.static.flickr.com/4052/...cc41a88ebd.jpg

Now just have to do the other side.... its a mess too.

http://farm5.static.flickr.com/4005/...55d4fa0a61.jpg

Nice Cap, very nice:clap:

Been there / Didn't think of that !
 

Very nice... This is a great fix for a common problem.

GREAT JOB, Kern!!...I like that ... :clap:

Looks good Capt.

were do you get the tuff board?

Home Depot has the tuff board. It works great for these type of applications. There is no heavy load on those boxes. The teak makes it very strong also.

Completed the other side today after work. Amazing how fast you can go when you have one done to measure from. Will post photos when they are mounted. Keeping them loose...while I run some new wires.

fpmarine.com sells them

rod boxes
 

i wish i could something like this but i have saddle tanks ??? maybe in frount of them from tank to helms:sun: