Re: Trailer Mods
 

Thats it. :(



Thats all I get. Good luck. >:(


Where's the " Call me when you are starting and I'll be right there" or "If you need help just call" or "it'll cost a few beers but I can help if needed". ???

Good luck.

Well I guess it's better than nothing. :-/








Just funning ya AIR, thanks for the inputs. ;D

Re: Trailer Mods
 

My last trailer had thin rollers like that. What I did is removed all, got new washers and hog rings, (yes you have them on the back of the roller) Place the roller on the arm and see were it need to ride. Drill new hole and add hog ring or big cotter pin, add roller, another roller and pin you are set to go!!
You have to think out of the box!!

Re: Trailer Mods
 

MJ about how much life should I be able to get out of them. This trailer came with the boat so I dont know how old they are.

Re: Trailer Mods
 

Turbo, ya need a hand? Actually serious on that. I'm in the off season now so I can get away now and then...Lost a fishing trip tonight due to that brake and I'm mad... >:(

Airslot

Re: Trailer Mods
 

Air: I'm not ready to start just yet, but if you want, you can stop by just to look it over and offer suggestions. Due to work schedule it will be the 26th before I can devote time to your Royal visit. ;D

Re: Trailer Mods
 

Turbo...you trailer no rock or roll ?? :-[ ...


...but that's a GREAT job on the axle/ springs !! ... 8) ...thanks for postin' all the pics ;) ;D ...

Re: Trailer Mods
 

Royal Visit scheduled for 1/26, really, I wrote it on my schedule ;D

Air

Re: Trailer Mods
 

When I did mine I use all SS cotter pins and they never rusted again!
As for the washers you will have to go Galv. I got rid of my traier 4 years after fixing it and they were all still moving!

That said I use the next size roller, so if you have 3/4 holes go to 1" roller, this allows room for the rust to roll out of the center.
which is the main cause of frozen rollers! There is no room for the rust on the shaft to get out, so it just swells and then seizes the roller in place.

You will notice all or most new trailers have a square shaft. Two sides are rounded for the roller to turn right. the flat sides allow the crap to fall off the center.

Re: Trailer Mods
 

AIR: you got my cell number for directions?


MJ I like the idea of stainless cotter pins.

Re: Trailer Mods
 

I gotcha Turbo.

Air