|
|
#21
|
||||
|
||||
Re: Motor has no power
Quote:
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!! 
|
|
#22
04-23-2006, 12:19 PM
|
||||
|
||||
|
Re: Motor has no power
It certainly would SMELL better ::)...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
#23
04-27-2006, 04:36 PM
|
||||
|
||||
|
Re: Motor has no power
Well the motor is alive!!!!!!!!!!!!!!! ;D Cb came down today and we or he used his tester to check all the wires and we found that there is a break some were in on wire??
Said to hell with it and just ran a new one!! Started right up and rans like a champ!! Till CB put in gear, and, the prop hit a pipe on the ground :o Sounded like the motor blew at first!! Should have seen his face "PRICELESS"!! What is ity with him and my props?? Pic to follow!~
__________________
1986 V20 Old Fishermen never die, we just SMELL that way!!
|
|
#24
04-27-2006, 05:22 PM
|
||||
|
||||
|
Re: Motor has no power
Whew! I thought you were going to have to wrap a rope around the flywheel there for a minute....
Glad you gotter to work Maco! Blue
__________________
 1994 Wellcraft V21
|
|
#25
04-27-2006, 10:46 PM
|
||||
|
||||
|
Re: Motor has no power
CB, Looking confused! It was a little touchy for awhile, thank god I bought the manual for this motor when I got it!!
 10 pounds of wires in a 5 pound box :o  CB getting ready to clean the Bunker oil off *:P Note the smile on his face!!  and the clean up  And whatn do you know it works!! ;D *It ended up being the red wire from the CDI unit to the control box. Must be broken some were in the line? We decided the best wat to deal with it was to just run a new wire right from the CDI to the control box. Better then trying to tear the harness apart and getting into a real nightmare!!  The Boss is checking to see if all is ok!  Thanks CB!!!!!!!!!!! Couldn't have done it with out ya!! :-*
__________________
1986 V20 Old Fishermen never die, we just SMELL that way!!
|
|
#26
04-27-2006, 11:30 PM
|
||||
|
||||
|
Re: Motor has no power
My pleasure Bud. Now, it's Squid time! That boat should have some serious ink on the decks next week.
And BTW, the red wire was to the voltage regulator. Once we ran a new wire, that baby fired right up nice. A bit smokey after the long winter, but she cleared up and idled down just fine. 8)
__________________
Heavily medicated for your protection.
|
|
#27
04-28-2006, 01:04 AM
|
|||
|
|||
|
Re: Motor has no power
Great pictures Mac. I'll be pulling my control box off in a short time as well. Need to replace the tilt trim switch in the handle.
BTW, your boat looks pretty damm good with that bottom paint. ;D
__________________
|
|
#28
04-28-2006, 10:51 AM
|
||||
|
||||
|
Re: Motor has no power
Quote:
Quote:
__________________
1986 V20 Old Fishermen never die, we just SMELL that way!!
|
|
#29
04-28-2006, 11:43 AM
|
||||
|
||||
|
Re: Motor has no power
Thanks for saving Mr. Bitterman CB, would have been a lotta Wind Talking the next couple of weeks if he didn't get that boat in the water ;)
__________________
Willy 1986 V20 Old School 1992 V20 1992 150 Yamaha 1997 HydraSport 2250 Vector 2009 17' G3 Outfitter "G Spot" http://www.youtube.com/watch?v=TDebw...eature=related "I won't be wronged, I won't be insulted and I won't be laid on a hand on. I don't do these things to others and I require the same from them" JW
|
|
#30
04-28-2006, 11:50 AM
|
||||
|
||||
|
Re: Motor has no power
That my friends is how to do a "Repairs" post...
-State and record yer problem in a new post. -BS around with alot of us that don't know our butt from a hole in the ground -Bring in an expert to diagnose and fix problem -Record the analysis and developement phases with digi cam -Post all and try to edumacate the masses -Post jabs at expert for comedic value in post -Thank expert and promise to give a kiss next time he comes over :o Nice goin MJ and CB! Now ink that deck up will ya?!!
__________________
1994 Wellcraft V21
|
 |
|
|
Linear Mode
