92 johnson 175

[macojoe]

well I and a friend just took a 1985, Yamaha 40hp, it was all messed up!!

Pulled the plugs, dumped Marvel in there came back 2 days later and tried to start, *Took a min, but that thing spun like a well lubed women!

Pulled the carbs, took bowls off cleaned jets and what not.

Yesterday the thing started and ran like a champ!

But not pumping any water, removed the lower unit and will be replacing this week.

This is on a motor that I said should be trashed!! I gave it no hope what so ever!!

So give it a shot, don't spend anything on it, just oil it up and see what happens!

good advice maco. nothing to loose. realy dont wanna notch my transom to mount my old 150. planning on getting this 175 running someday soon. even if i have to rebuildit. heres my info schools. mod #- VJ175EXENC ser#- G03064923. cant thank you guys enough. anytime i go to a boat yard i always feel likr a woman at a mechanics shop. not realy sure what there talkin about but, buy the grin on thiere faces, i'm pretty sure i'm getting screwed! glad i found this forum! now i dont feel quite so lost. thanks guys.

[phester]

very similar to my #'s.... I think it's a 1992 you got there

[Skools Out]

VJ175EXENC means

V= Boat Builder motor design
J= Johnson
175= Horsepower
E= Electric Start
X= 25" Shaft
EN= Motors Year (E=9, N=2 means 92 yr)
C= Model Run ( C means 3rd run that yr)

tx scools. with that said, i got a question.i am fairly mechanicaly inclined. built a couple hot rods, swapped a few motors. not much outboard xperience, learnin as i go.roughly, what am i lookin at to find a powerhead and swap them out? dollars and sense? money is tight, new baby. could i rebuild for less bucks?tx bro

[Skools Out]

you have nothing to loose open it up and send me pics of the insides first actually take the heads off the motor post pics of the cylinders that will help on the cost of a rebuild. look on ebay and find you an OMC or Johnson /Evinrude motor shop manual for your motor find the one for the 1992 motor in your HP it will walk you through all the tear down and rebuild.

[Skools Out]

here's 2 of the manuals you need. the EN which means 92 is actually the one you need but these should work.

This one is a JOHNSON EVINRUDE FACTORY SERVICE MANUAL EI 60 degree LV MODELS 150 175, the EI means 1991 Manual
http://cgi.ebay.com/ebaymotors/JOHNS...QQcmdZViewItem




This one is a JOHNSON EVINRUDE FACTORY SERVICE MANUAL ET 60 degree LV MODELS 150 150C 175, the ET means 1993 probably better for you than the 1991
http://cgi.ebay.com/ebaymotors/JOHNS...QQcmdZViewItem

[Skools Out]

yikes here's a 1992 on ebay but it's high, I'd say the 1993 would do just as well buy it at a cheaper price but either way this is the type manual you need.

1992 150 175 HP REAL EVINRUDE JOHNSON EN SERVICE MANUAL *

http://cgi.ebay.com/ebaymotors/1992-...28797371QQrdZ1