New Dive Platform - Page 11

msbhammer · #**101** 05-31-2007, 06:44 PM

Accepting free donations and labor to finish her up. ;D

randlemanboater · #**102** 05-31-2007, 07:14 PM

Thats a nice looking diving board you got there Hammer, but I think it will get in the way of fishing. ;)

msbhammer · #**103** 05-31-2007, 07:59 PM

Not when your spear fishing. ;D

macojoe · #**104** 05-31-2007, 10:06 PM

I think before your done you will cut back that starboard from the motor!
And you are going to mount the ladder and have to much lip, I think I would trim it close, and round over with router bit.

msbhammer · #**105** 06-01-2007, 12:41 AM

With the staboard being 3/4", I guess there is a router bit that can do 3/4" curve ??? ???
Guess I'll be at Lowes checking out routers on Friday.

lumberslinger178 · #**106** 06-01-2007, 01:13 AM

Quote:

Originally Posted by MSBHAMMER

With the staboard being 3/4", I guess there is a router bit that can do 3/4" curve ??? ???
Guess I'll be at Lowes checking out routers on Friday.

let me know i can bring anyone u want ;D

reelapeelin · #**107** 06-01-2007, 11:37 AM

Hammer...3/8" to 1/2" roundover is all you need ... 3/4" bit on 3/4" material is too much ... if ya go that deep, you'll need a router table w/a fence to follow the edge...smaller bit w/ a roller tip will follow the edge of the material ... and look better INMHO ;) ...

macojoe · #**108** 06-01-2007, 12:10 PM

If I was going I would have brought all the stuff with me, I have the router and all the bits.

But Lumber has you covered!! I hoope he knows how to use it ;) ;D

msbhammer · #**109** 06-01-2007, 01:24 PM

Reel, your correct. I ran out to Lowes to just look...and seen that router bits are only 3/8 or 1/4 runover.
Well the starboard is in your corner now Lumber, show me what ya got. ;D ;D ;D ;D

reelapeelin · #**110** 06-01-2007, 03:04 PM

I've got a 3/4" roundover I used for the panels under the dash... you can use if you want, but I think it's WAY too much for 3/4" material...