battery placement

[phatdaddy]

lot of that equation is motor choice.

[Slightly_Twisted]

Well I***8217;ve some time to work on the boat. Finished all the removal, just need to clean the boat up and start installing all the new wiring. There where soooooo many wires rusted off their connections no wonder why things didn***8217;t work! I also pulled the gas tank cover to one replace the ground wire and two inspect the tank. Looks good from what I can tell dry foam and no gas in the bottom.

I ran the main starting wires from the bow to the stern to make sure they were long enough, and I was able to use the 2 AWG I had already,, next will be the battery switch and the new fuse box when I have some time.


I was thinking about putting a new set of gauges in, but dont want to spend the money if I cant use them for multiple engines. Is it possible to do that? Buy a set now use them for the seadrive then use again for when I repower?

[randlemanboater]

Looking good.

I don't know that you will find any gauges that would work with your old school 2 smoke and a modern motor...I guess it depends on if you are planning to go modern with your next motor.

[Slightly_Twisted]

hey guys quick question.

I'm putting in 6 LED deck lights what terminal wiring is better? All wire will be individual run pairs to each light. From the switch to one of the following terminals.

something like this

https://forum.ih8mud.com/attachments...ng-jpg.237958/

or using one like this

https://www.ebay.com/i/291855967186?rt=nc


I like the second one for WAY less connectors used.

thanks

[SkunkBoat]

Originally Posted by Slightly_Twisted

I was thinking about putting a new set of gauges in, but dont want to spend the money if I cant use them for multiple engines. Is it possible to do that? Buy a set now use them for the seadrive then use again for when I repower?

A lot of new motors,even without digital controls, have a single all-in-one gauge Tach with leds for temp/ pressure/engine alarms...no need for extra gauges

[Slightly_Twisted]

Skunk,

If I did run a single pair what splice would you recommend?

thanks