|
|
|
|
#1
|
|||
|
|||
So after I get the plywood peeled off I mix some epoxy resin and pour it in the shell then lay the ply in that? Is that right? Next I would need to resin the top WITH cloth or no? What would be good to clean the shell with after I get the ply scrapped out so the new resin and ply stick? This is the tank cover / seat support so it gets a LOT of use sure don't want the ply coming loose. Thanks!
|
|
#2
03-15-2015, 10:45 PM
|
||||
|
||||
|
I would hot coat the plywood and used thickened resin on the shell. I used a notched trowel to spread the resin on my hatches. I also used pieces of plywood rather than a full sheet. I cut my plywood to fit then I cut the piece into smaller pieces and left a little bit of space in between each piece. Then I forced more thickened resin in the joints and glassed over the top. I was very happy with the strength, we'll see how it holds up.
__________________
1999 Wellcraft 22WA-200 Ocean Runner 1982 Grady White Tarpon 190-110 Evinrude-Sold 1996 Striper 2100WA-RIP Sandy 1989 Wellcraft 18-Sport-125 Force-sold
|
 |
|
|
Hybrid Mode
