|
|
#1
|
|||
|
|||
Removing 5" extension from Exhaust Tube
I have a 25" mercury 150 engine and a 20" mercury 150 HP parts engine. Same vintage so most parts are interchangeable. I am trying to remove the 5" extension from the 25" engine exhaust tube and it does not seem to move at all. I don't want to break or damage anything, - so what is the trick? I don't see any fasteners on the engine or in any parts sketches. Any help is appreciated. Thanks
__________________
1978 V-20 Steplift 1988 Mercury 150HP 
|
|
#2
08-24-2014, 10:15 AM
|
||||
|
||||
|
heat, lots of it. You may have to remove the studs before you can get it off the mid section
|
|
#3
08-25-2014, 01:37 PM
|
||||
|
||||
|
The exhaust cans are identical on the 20,25" and 30" motors as I recall. You sure you have to remove 5" of it? LOL!
__________________
 1996 -19' NV Flats 115 Mercury 4-stroke 1983 -20' Wellcraft Center Console 250 XS
|
|
#4
08-25-2014, 01:38 PM
|
||||
|
||||
|
I am thinking 3.0Liter Merc stuff. The 2.0,2.4,2.5 might be different, nevermind.
__________________
1996 -19' NV Flats 115 Mercury 4-stroke 1983 -20' Wellcraft Center Console 250 XS
|
|
#5
08-26-2014, 09:08 PM
|
||||
|
||||
Quote:
__________________
1985 Wellcraft V-20, Evinrude ETEC 150: SOLD 1979 Marine Trader 44, twin Ford Lehman 120s 2006 Panga 14, Tohatsu 20
|
 |
|
|
Linear Mode
