Im not sure its gonna be a V20 anymore!

[macojoe]

BenFishin Something i have been pondering
I was thinking about getting a porta bracket but in reality i am not gonna be able to afford it. I have a bracket that was on the boat before i redid the transom but the way it was set up was for a 20" motor and had a manual jackplate to run a 25" motor. I would like to do away with the manual jackplate. So can i just move the bracket up to use it as a 25" motor? or will that create too much of a moment on the transom? I know there is a calculation for how high to mount it based on the set back but i am just lookin to see if i can use it as a 25" bracket for now. If not would someone like to trade?? haha Today 01:49 AM

You can put the bracket any were you want no need for a new one. As for the height, I believe it is up 1 inch for every 12 inch of set back.
I did not do it with mine I just went to the 25 line and was fine. But you must use a 25" shaft and use the smallest set back you can for the best fit.
I had a 28" set back and it was nice to tilt a V6 all the way up, but after a few others have converted theres we found that the best way is to use a smaller set back, but your is fine cause you can't change it any way.

Keep up the good work, can't wait for the finish.