1987 Looper v4 140 RPM only 4000

[Skools Out]

Originally Posted by nymack66

I was told my engine is a 1987 E140tlcua,

Originally Posted by nymack66

I remove a SS 14x3/8 x 19 only going 3000 to 35000 rpm, I install a 14.8 x 17 aluminum it is a 15 spline prop 3 blade.

Wrong lower unit you have a V6 lower unit none of the short shaft 20 inch motors had 15 spline lower units, they had 13 spline. Only the 25 inch 120/140 motors had 15 spline lower units. It could still be a 120 power head. My 120 and my 2 twin 140's both have 62D jets.

[THEFERMANATOR]

They did offer the bigger lower unit on 85 and some 86 140's, seen em with my own eyes. And I have 2 140 lower units that are both 13 spline V4 units. Your model number comes out to a 20" shaft, but you said before IIRC you said you have a 25" leg. Your carb numbers come out to an 86-early 87 140 carbs, but it could still have a 120 tuner and reeds which would give you a 130 I believe. I think you need to verify your tach, and then check your timing.

[Skools Out]

right ferm 13 spline but he said he has 15 spline that's either a 25 inch lower unit or a V6 which he has neither of. no 15 spline were on V4 motors with 20" shafts.