1989 Evinrude 110hp 20" shaft

[randlemanboater]

Man, wish I had a boat I could use that on.

[smokeonthewater]

I wish I could figure out a cheap way to get it here..........

[Striper80]

Side mount binnacle included.

[smokeonthewater]

Loooooooong shot here..... Sooo if I could arrange a semi to meet you at an exit on I-95 would you have any way to get it on a pallet and loaded on the truck?

Maybe a rollback???? Hmmmm

[Striper80]

Depends on what exit. Since I dropped the price and advertised it a little more I've had some more interest.

[smokeonthewater]

I've got a friend who runs up that way but he can't go out of route... I believe any exit would work as long as it's easy off and on for a semi and has a place to park and make the exchange.

[Striper80]

If the semi has a hydraulic platform on the back of it, it might workout. Right now I'm kind of stuck since there's a boat in front of my garage and its snowed in.

[smokeonthewater]

It would just be a regular 53' van trailer.... That's why I was thinking the roll back if the bed was high enough to drag the pallet into the trailer or maybe even roll it in w a pallet jack.

[Striper80]

I have a GMC Sierra 1500 with a 2" lift. The bed's about waist high.
I just disassembled the binnacle to repaint it and dye the faded red handle.

[smokeonthewater]

Hmmm lemme do some figuring.... If you think about it measure from your tailgate to the ground.... Still a bit of a long shot but I'm tryin....