Motor pic

[2ndchance]

Thanks Skools out. I willgive it a try later this week. Yes that was the Renkin. The hull has a crack that runs down 40 to 80% of the port side chine, and the transom had spider web cracks above the bracket. That transom was no where close to the beefieness of the V-20. Right now I have to get back to my jig saw puzzle AKA the cabin door that I found in pieces among the 2' of leaves. I will post pics on that later. ;D

[msbhammer]

OK, ITS LATER, WHERE ARE THE PICS. >:( >:( >:( >:( >:(

[2ndchance]

But my, aren't we impatient. ;D ;D

[reelapeelin]

Originally Posted by 2ndchance

But my, aren't we impatient. ;D ;D

Ya gotta understand...he's outta DONUTS!!... ;D ;D ...

[msbhammer]

To cold for donuts. Heater went out on us this morning.
Just living off of body heat and her one thong to keep warm in the house. :'(

[reelapeelin]

Originally Posted by MSBHAMMER

To cold for donuts. Heater went out on us this morning.
Just living off of body heat and her one thong to keep warm in the house. :'(

Sorry to hear heater down...bad timin'...hope you guys do OK :-[ ...

[macojoe]

Go to How to section, New instructions on how to post pic

[msbhammer]

Heater man is here now. 90.00 bucks an hours. There goes my overtime check to get my tilt trim and volt reg. working again. :'( :'( :'(

[parishht]

Sorry HAMMER, wish we lived closer together,
I would have come over and taken a look for ya.
Living in an old house, I work on all my own heaters and stuff.
I also have a really cheap heater guy that I call when I get stuck,
sort of a friend of the family.
Last time I called the guy, he rebuilt my heater and only
charged me $60.00.

[msbhammer]

Heater bill was $400.00 big bucks :'( :'( :'(
Had to replce the pump. Wasnt pumping oil into the furnace. No more work on my V for awhile now. :'(