21 FT Project Boat Part 1 Getting Close

[Skools Out]

well been 2 days my epoxy hasn't dried enough to sand :-/ that i filled some gouges with. So i worked on the V20 tonight and did transom work. measured the transom with a string to see if it was smooth continued curve but it was off on one side by a 1/4 inch.ugh >:( so i ground on it till she is even all the way around. then spread epoxy with ballons to make smooth. now she is looking goooooooood. now got to line sand smooth then going to lay 1 piece of glass over whole transom from 4 inches under to over in well and 4 inches over the cap. she will be strong.