Oil alarm

[spareparts]

its looking for a signal from the sensor

[steplift20]

Please bare with me, the oil pump/gear sensor has three wires,one is the ground and the other two are for something. What I would like to know is if I disconnect the two wires and hook it to a multimeter ( leaving the ground alone and hooked up) should I get voltage reading from the two wires? If it's working of course as the magnet turns internally.

[spareparts]

yes

[steplift20]

Spare thanks for taking the time to help me,I'm not good with electric but the multimeter question you answered for me is going to be a great help. That is what I'm going to do if I get no reading than its the motion sensor or the internal gear if I do get a reading than I'm going to replace the low oil and temp warning module. I found one on eBay ( new) for $260.00 that's the cheapest I found. Your a great help spare and really appriciate it. Thanks,

[spareparts]

make sure that thing is spinning before ordering the module

[steplift20]

I will spare,thanks.