|
|
#1
|
||||
|
||||
CNC Plasma Table
Anybody got any experience with plasma cutting, or using a CNC Plasma table? I'm looking to make it easier to make parts, but my medium is 16 oz copper which is 24 guage. I'm just thinking it might be too thin to get a good cut on a CNC plasma table. Then again, with the proper setup it could be magical. Anybody?
__________________
 1994 Wellcraft V21 
|
|
#2
05-11-2022, 03:23 PM
|
||||
|
||||
|
No metal heads here?
 I thought surely there's one or two.
__________________
1994 Wellcraft V21
|
|
#3
05-12-2022, 11:07 PM
|
|||
|
|||
|
Quote:
I'm in CNC milling and only have experience cutting steel with a handheld plasma cutter. I've heard cutting thin copper can be tricky, but is doable. Have you searched https://en.industryarena.com/ ?
__________________
1983 V20 Cuddy, 3.7L/165hp Mercruiser Fishing out of Portsmouth NH
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
