|  | 
| 
			 
			#41  
			
			
			
			
			
		 | |||
| 
 | |||
|   
			
			Thanks Skunkboat. I***8217;ve been doing something similar with the chain***8230;you***8217;re right, it really doesnt move around too much. I***8217;d rather not remove the bow cleat to make room for the tensioner. I imagine if I run the way it is for a bit I***8217;ll get used to it and quit worring about it. Thanks.
		 | 
| 
			 
			#42  
			
			
			
			
			
		 | ||||
| 
 | ||||
|   
			
			I just put an old speargun rubber through the anchor shackle, pull the anchor up and the pull the rubber up over the cleat.  Snubs it up fine  on the anchor  on the pulpit Also, if you're going to hang your anchor overboard, make sure you safety wire the clevis pin so it won't back out i watched the anchor fly off and heard & felt it hit the prop. Cost me about $400 to learn that lesson Last edited by phatdaddy; 03-30-2022 at 05:30 PM. | 
| 
			 
			#43  
			
			
			
			
			
		 | |||
| 
 | |||
|   
			
			Ouch!  Thanks for the snubber idea! | 
| 
			 
			#44  
			
			
			
			
			
		 | |||
| 
 | |||
|   
			
			I bought mine off Amazon. Fits well started with the cheaper aluminum ones and they have lasted 2 years so far and will at least this year too I guess. I can post the link on Amazon if you want I needed up getting an 8 ft one I think. Will post more details and pictures if you are still looking.
		 | 
| 
			 
			#45  
			
			
			
			
			
		 | |||
| 
 | |||
|   Quote: 
 | 
| 
			 
			#46  
			
			
			
			
			
		 | |||
| 
 | |||
|   
			
			Will get it done this summer and let you know. Just couldn’t do it this winter.
		 | 
|  | 
| Thread Tools | |
| Display Modes | |
| 
 | 
 |