![]() |
|
|
|
#1
|
|||
|
|||
|
I made a frame using horse brackets , the one you use for making a saw horse and used a 8 ten foot 2X4 accross the top and 6 foot ones for the legs and it's been working fine for years . I do put something under the legs cause that comes in contact with the deck
__________________
love to fish |
|
#2
|
|||
|
|||
|
My old boat I built a 2x4 frame and used tarps. it worked good but the frame was a pain to put up and take down.
the canvas cover doesnt have a lot of room to put the center up higher. Thanks for all the replies, except from the joker down south. haha |
|
#3
|
|||
|
|||
|
This winter I ended up putting an old saw horse near the transom to keep the peak and didn’t really see much snow accumulation, but I did go and knock off the snow after the couple of storms we had. I might end up with the sawhorse clamps idea next year, just that my cover was a bit smaller than I planned for, so maybe the next cover I will do it.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|