V20 Cuddy I/O Motor Box

[3 Squids]

This is the only handle on mine. Located on the top at the rear. Only handle I’ve needed. Mine has a spray type foam in the box for sound.

9C684062-DAE3-42B6-9A8A-36E32ED91888.jpg

[cmk245]

Good idea Flush handle. was that there from Wellcraft, or installed by you ?

Mine has one on the front lower, also which looks like factory, as I have seen alot of earlier V20"s with one there.

So is spray foam, mine is just raw resin covered wood and glass.

Did Wellcraft ever put something on the inside?

[3 Squids]

I don’t know if my latch and insulation is original or not. I know it’s well built. I’m 280lbs and stand on it all the time to sight cast and have never had a problem.

[Dschaffer]

Originally Posted by 3 Squids

This is the only handle on mine. Located on the top at the rear. Only handle I’ve needed. Mine has a spray type foam in the box for sound.

Attachment 7976

Mine is an 88 and has the same set up as this picture. I don’t have any latches and that’s never been an issue. Hopefully I remember to take a couple of pictures to share sometime tomorrow. For whatever reason, I don’t ever get notified about posts on this forum (I do subscribe for email alerts).

[cmk245]

Don't feel bad, I don't get email notifications either, and checked the box for them.
If I don't check the Forum, would never know i got a reply....

Thanks for your reply.