|  | 
|  | 
| 
			 
			#1  
			
			
			
			
			
		 | |||
| 
 | |||
|   
			
			Well I took spare parts advice.  I was nervous bridging those wires.   Electrical scares me.     But it worked!! I got spark once I briefed them.      So I need to figure out if it***8217;s the key switch, kill switch, or then engine harness being grounded out. Any tips or advice on how to accomplish this?? Spare parts is my hero! ***128514;***128514;***128514; Last edited by AcogDoc; 05-05-2020 at 04:17 PM. | 
| 
			 
			#2  
			
			
			
			
			
		 | |||
| 
 | |||
|   
			
			None of the colors on this ignition switch match the mercury service manual.  And the service manual only outlines if you have a side mount throttle control.  I have a dash mount throttle control.    I’m so lost
		 | 
| 
			 
			#3  
			
			
			
			
			
		 | |||
| 
 | |||
|   
			
			Well I checked the key switch and what not now I have spark (makes no sense) but I only have spark on 5 cylinders one cylinder isn***8217;t producing spark .   Checked the grounds and switched a coil.   The problem didn***8217;t follow the coil so I***8217;m just at a loss
		 | 
| 
			 
			#4  
			
			
			
			
			
		 | ||||
| 
 | ||||
|   
			
			Swap the switch boxes and see if the problem follows.  When the motor was running, was it charging ok?  Was the tach working?
		 | 
| 
			 
			#5  
			
			
			
			
			
		 | ||||
| 
 | ||||
|   
			
			Hey Acog, Spareparts is a hero to many on this site other sites around the world wide web!!      
				__________________ 1994 Wellcraft V21 | 
| 
			 
			#6  
			
			
			
			
			
		 | |||
| 
 | |||
|   
			
			I’ll try swapping out the switch boxes and see if that does the trick
		 | 
| 
			 
			#7  
			
			
			
			
			
		 | |||
| 
 | |||
|   
			
			And when it was running the tach was working and it was charging I believe.   I have two batteries in a switch and never need to change to the back up battery.
		 | 
|  | 
| Thread Tools | |
| Display Modes | |
| 
 | 
 |