Has it ever been done?? Well it’s about to happen.

[3 Squids]

Originally Posted by bgreene

Also- V21 trim tabs needed - especially if 200 hp.
Will pound without in chop but ride nicely with.

I have a brand new Lenco tab setup still sitting in the box. I believe they are 9x12. I was planning on using them but not sure if they’d be too wide with the setback transom. Do you have a pic of your trim tab setup?

[bgreene]

Originally Posted by 3 Squids

I have a brand new Lenco tab setup still sitting in the box. I believe they are 9x12. I was planning on using them but not sure if they’d be too wide with the setback transom. Do you have a pic of your trim tab setup?

Happy to assist with pic- tomorrow

[bgreene]

http://www.wellcraftv20.com/communit...1&d=1533225749

Why are the pictures sideways ? No idea........but just turn your computer around :) and you'll see I provided you with two pictures of each side - including under so you can see how I lined up with bottom of hull .

[Pipe_Dream]

Originally Posted by bgreene

http://www.wellcraftv20.com/communit...1&d=1533225749

Why are the pictures sideways ? No idea........but just turn your computer around :) and you'll see I provided you with two pictures of each side - including under so you can see how I lined up with bottom of hull .

Nice work.

[bgreene]

Thanks - how’s the 175 Zuke been for you - fantastic fuel economy ?

[3 Squids]

What size tabs? Mine are 12”w by 9”l. Yours look narrower.

[Greyduk]

3 Squids, Did the V-21 have a windshield when you got it? If so would you want to sell it? Thanks.


Fred