Has it ever been done?? Well it’s about to happen.

[Destroyer]

I know that a lot of people say that a 150 is the ideal horsepower for a V20 but to my mind a 200 is way better. Granted you cannot normally use that much speed on the ocean because of the waves, etc. but on a smoother lake or river it is just a sweet ride at WOT. Your dad's boat looks nice.

The gap I was talking about is inside your boat. if you stand inside and look at the stern where the bubble comes through the transom. Follow the stringers and there's a place where the vertical stringers go through the horizontal stringers + They could have been joined together for more strength but Wellcraft didn't do it. They left a gap between them of about an inch. That's the area I was talking about. Hard to tell from your pics if they did that on your hull but that was the case on mine.

[3 Squids]

Yea I like a 200 on these hulls but a 150 does its job. For this project I have a 2004 Johnson 175 so I guess I’ll have the best of both worlds?? I bought a 20’ Palm Beach center console that needs a floor. It’s just been sittin because well, it’s really not my style of boat and I haven’t wanted to spend the time or money on it. But it was a deal I couldn’t pass up. I can easily part it out and get my money back but instead I am just going to part it out to myself for the V-21. I now have a console, T-top, leaning post, motor/rigging, fuel tank etc. The trailer it’s on is also nicer than the one the V is on so I’ll swap that out to.

8363111B-F124-4610-AE22-75965EE39830.jpg

If anyone local wants this Palm Beach hull when I’m done she’s free to a good home. Needs a floor and the PO cut some of the floor out and it’s been open in the rain so I’m sure the foam is logged.

[Destroyer]

Interesting. https://www.ebay.com/itm/1986-Wellcr...gAAOSwx95bFWi4

[3 Squids]

Originally Posted by Destroyer

Interesting. https://www.ebay.com/itm/1986-Wellcr...gAAOSwx95bFWi4

That an 18’ right?

[Destroyer]

Yes. Still... it's an interesting find for anyone looking for a smaller boat.

[1224bret]

I’m actually in the process of converting my cuddy to a cc and am doing it like you are glassing the floor directly to the sides setting on top of the stringers. Looking forward to your progress pics.

[1224bret]

Here’s a pic that kinda shows what I’m doing. Completely built console from scratch not quite finished with it yet.

[3 Squids]

Originally Posted by 1224bret

I’m actually in the process of converting my cuddy to a cc and am doing it like you are glassing the floor directly to the sides setting on top of the stringers. Looking forward to your progress pics.

Originally Posted by 1224bret

Here’s a pic that kinda shows what I’m doing. Completely built console from scratch not quite finished with it yet.

Very nice. I can’t wait to get mine started. Unfortunately work is keeping me away from it recently. I did manage to have 10 free minutes yesterday and I dug into some of the foam and just as I suspected the last inch or so was solid water. I had dental surgery yesterday and by doctors orders took today off so I plan on going out today and getting the foam all out and clean her up and get a cover on her.