battery placement

[Slightly_Twisted]

Few more. I***8217;m working on a anchor pulpit, will mount a kicker engine bracket, and clean her up there is fiberglass dust EVERYWHERE!


The last thing I did was go way out of my comfort zone and removed and replaced all the zippers for the encloser. I found out I***8217;m not good at sewing! But I should work I just have to test them on the boat.

[jvitiel]

Looks awesome. Lots of well thought storage and love the battery boxes. Will be interested to hear how you feel about the new weight distribution when running..

[jvitiel]

What are the batteries sitting on?

[Slightly_Twisted]

I made a mold of closed cell foam then topped it with a 2x12. Drilled a few holes and poured some two part foam in. Once is was dry and stabilized I used some stainless steel L channel and screwed the 2x12 to the bulkhead and stringer. On top of the 2x12 I used some shop flooring pad under the battery box. The pourable foam underneath will conform to the hull so there is no way it could damage the outter hull, but it will also hold up the side near the step down. I didn’t screw in that side.

[jvitiel]

Good plan. Thanks for the insight..