not done with that part yet, i installed a bilge blower with a inlet vent on the port side of the tank. the blower attached to the rear right side of transom. i have to make a hole for the vent on outlet side of blower. my tank is sitting a little higher than before and i don't want to use foam, i use starboard panels glue with 5200 to the bottom and angled sides of the cold tar epoxy fuel tank. will use marine plywood, seal with polyester resin screw to the sides to hold it down. now i have to find some teflon wrap so i can wrap around the fuel supply line i don't want it chaffing against the fuel tank panel.
|
Hybrid Mode
