Thinking about a 2nd V project.

[3 Squids]

Originally Posted by Troutkiller2006

. you got a boat in the water. your not missing out on anything cause your boat isnt finished. you can take your time, do it right. you will never cut a corner

This is my exact thinking. I can take 2 or 3 years to build a rock solid, life long boat as long as I have one I can use regularly.

As for the wood in the boat, ideally I would like to have no wood at all in the boat. Seacast is the pourable stuff correct? I have a bad taste about some composites as my buddy's boat had a composite floor put in and around his gas tank it actually got soft and spongy due to water getting in screw holes. I thought that was the sole purpose of the composite?? Not sure exactly what it was but I need to try to find out so I can avoid it.

[bgreene]

DESTROYER - I share your thought process of matching / swapping / rigging from more than one rig to set up another......

I " run this equation " when I start thinking about next boat possibilities.

In a minor way, I did so by selling my last boat, buying the V21 for 1/2 the sold boat money, then using the $$ to buy new trailer, and rig it with used low hour Etec 200 HO, and sold the motor it came with........a great evinrude !50 looper.

It can be a good way to limit the spend ( sort of ) by using older boat packages where it can work out.

[Destroyer]

Originally Posted by bgreene

DESTROYER - I share your thought process of matching / swapping / rigging from more than one rig to set up another......

I " run this equation " when I start thinking about next boat possibilities.

In a minor way, I did so by selling my last boat, buying the V21 for 1/2 the sold boat money, then using the $$ to buy new trailer, and rig it with used low hour Etec 200 HO, and sold the motor it came with........a great evinrude !50 looper.

It can be a good way to limit the spend ( sort of ) by using older boat packages where it can work out.

Exactly. I'm pretty much hoping to eventually break even. I have 2 single axle boat trailers that fit 20' boats, both galvanized, heavy duty, no rust that I intend to sell after I do the mentioned swaps. And the 225HP Looper Johnson that's on the V20 now will get sold for a profit in the spring when people are looking for engines. That money will go into Destroyer's Etec bank towards my future (and hopefully last) engine swap on the V21. (Although Yamaha is a serious contender right now for the final engine swap also)

[Troutkiller2006]

Originally Posted by 3 Squids

This is my exact thinking. I can take 2 or 3 years to build a rock solid, life long boat as long as I have one I can use regularly.

As for the wood in the boat, ideally I would like to have no wood at all in the boat. Seacast is the pourable stuff correct? I have a bad taste about some composites as my buddy's boat had a composite floor put in and around his gas tank it actually got soft and spongy due to water getting in screw holes. I thought that was the sole purpose of the composite?? Not sure exactly what it was but I need to try to find out so I can avoid it.

yes, seacast is the pourable stuff. been around long enough that i would call it proven technology. i have it in my transom and stringers and im impressed. but do your own research, theirs lots of info out there. as for your buddies boat... probably more to do with craftsmanship than material. anddont be afraid of foam either. tons of horror stories of waterlogged foam. pretty sure my dually has that issue cause it list hard to stbd. i just correct it with my tabs for now. but when the fishing slows down and i redo it i wil absolutely put foam back in every single air void in it. good quality products that are properly installed...there is absolutely no reason not to use current technology on these old boats