1998 Johnson 200 check engine light

[Striper80]

Yeah the alarm sounds right after the system check is finished. It sounds for like 10 seconds then stops, the light stays on. It doesn't sound again until I shut the engine off.
I looked on my 96 130 to see if it had the sensor but it doesn't. My boat's about an hour away and I won't be able to get to it until Saturday.

[THEFERMANATOR]

Try unplugging it and see if the alarm continues to go off.

[Striper80]

Which plug is for the sensor? Maybe I left it disconnected when I repaired the tilt trim inadvertently. The first time I started it was at the ramp on Sunday since repairing it.

[THEFERMANATOR]

Find the fuel restriction sensor(should be a small round canister with 1 fuel line hooked to it mounted to the VRO bracket), and follow the wires from it to the harness. With it unpluged it should not work as it is a switch that closes under vacuum.

[Striper80]

Thanks I'll give that a shot.

[Striper80]

So I was able to get down to the boat and check out a few things, but I wasn't able to run it due to it being too late at night. I found a t fitting leaking right before what I'm guessing is the sensor for the check engine light. The sensor for the check engine light is the one that the wires fell off, but reattaching them didn't cause the light to go out.
I'm going try and find some type of non conductive epoxy or rubber to refil the cavity of the sensor and fix the leak and do some further testing this weekend. I still need to see why I had a "no oil alarm" momentarily. The tank was low but I never got a low oil alarm. One thing at a time and I'll run it premixed for a little while on a separate tank.
The sensor is the white thing below the vro.