tilt

[bradford]

Originally Posted by spareparts

If this works, you owe me 1 12 pack of Natty

Easily worth a case, more really, and understand about doing stuff for cheap/free, word gets out and soon you're stuck doing everyone a favor. Don't do it and you're an A--hole. It's a thin line in a gray area.

[spareparts]

I finally had to stop taking phone calls between April and September, my voice message says to send me an email to schedule service, I still take 15-20 calls a day

[Blue_Runner]

Well I know I speak for everyone when I say I appreciate your words of advice. You've helped a lot of people, along with other members of the site.

I tried to get it going today. Did the procedure many times. still leaks down quickly and refuses to go up. Will trim up but not tilt up. Must be sucking air from somewhere. Sucks cause my favorite time to fish is nowish until november. Not sure the next step I should take?!?!

[Blue_Runner]

I'll still buy you a box of fatty nattys if I ever make it to Charleston!

[spareparts]

sounds like you still have air in it, trim it all the way up, you may have to help it a bit. Let it sit over night and top off the fluid again. Make sure themanual release is tight and try it again

[Blue_Runner]

Just did that. Think I got a little more in there but no change in behavior. I notice sometimes after trimming up I hear air when I unscrew the fill screw. Then I'm able to add a minute amount of fluid. Other times I hear nothing and fluid comes out when I unscrew the fill screw. Yesterday before I worked on it it would ever so slowly try to move up when tilted in the up position. Ever since then it wont even do that. Looking at the parts diagram looks like there's supposed to be an o-ring on the fill screw - I see none on this one?? I put some thread tape on it to see if it helped but cant see that it did.

[Blue_Runner]

Was making some progress - got it to go up under load (a little). I took pins out to make it easier to up/down between bleeding. Apparently I got too much fluid in there as now I've cracked the freaking reservior!

Anybody want to come over and have a couple beers around the fire while I burn $800 on a used trim assembly? I'm officially done with this thing. Maybe i can part this one out? Freaking Yamaha new parts prices are ridiculous. Thanks to everybody for trying to help!!!!!!

[steplift20]

Hey spare if I run by you can you check out my whole engine and of course don't charge me that said you sound like a great mechanic ,could I be your best friend please My motor is old and I need all the help I can get

[steplift20]

Did you check ebay for the part I had to get a used trim assembly and the only place was ebay paid 400 dollars ans paid about 150 to have it installed worked ok for about six months then had to get a new trim motor, that cost me 800 so I'm into this for about 1500 I wanted to get a new unit from the start but they don't make them any more Thanks mercury Oh and now they don't make the motor anymore from the company that I bought it from so if I have to replace that I hVe to buy from ebay yep the warranty expired 1 year My advice to you is if you can get a new assembly I know it's a lot of money but it will be cheaper in the long run

[Blue_Runner]

Yes, i bought the one from eBay. A new trim assembly with Yamaha pricing is a scoach under 3 grand. My motor might bring $4500 - 5k on a good day. Boats.net prices a new trim unit at $2500 and change. I'm into this one for around $830. I can do this three times for what a new unit costs.......if I don't sell it and hang a 4 stroke on the back.