Va Beach v20 project

[SkunkBoat]

Originally Posted by Kracker Jack

The Bollard/Bit was kind of an overkill. I had it laying around and said to myself it will look badass on this ole classic. I will be putting a bow roller on it at some point. I do alot of tautog fishing and i like the get the rope vertical over structure......it makes for alot of pressure on a cleat setup

This Lewmar tilting roller works great and holds the anchor in place, ready at all times.

[Kracker Jack]

One happy KRACKER!!!! Went to camden,nc after work today and picked the new motor!

[bradford]

She's really looking sweet! Love the sampson post and the hawse pipes too. I've found thicker anchor rode, like 5/8" or better works better at going through and not getting tangled. Also dig running the wire through the leaning post.

You should be very proud, she's a beauty!

[Kracker Jack]

Ran the the harness and shift/throttle cables today. Set the console up and installed key/kill switch and binnacle. And put second coat of spar varnish on the wheel base.

[SkunkBoat]

isnt it great having only one gauge!!!