Questions about I/o to outboard conversion

[1224bret]

Getting a little closer to getting this thing back on the water... Got the lower unit back from the shop Friday and installed it yesterday they were very reasonable on the price for putting the new shaft in but I've been burned so many times on lower units I'll wait to pass judgement on the quality of the work until it's on the water. Got all the rigging done on the engine side except for water pressure hose for gauge. Still have to wire everything in the dash since I've changed so much up there. And still collecting penny's for the hydraulic steering. Hoping to be done towards the end of next month but we shall see I said the same for getting it done by the end of this month and now I know I won't make that happen.... So far really happy with the way it's all coming together!!

[RidgeRunner]

Progress sometimes takes a little time.. Just in time for Scallop season, or some kind of season, somewhere...

I had to say it... Get that phone out... snap a few pics and post them

[1224bret]

Not the greatest pic but taken just after installing the lower on the engine

[1224bret]

Dang it! Of corse the pic is sideways! Why wouldn't it be!!!!

[smokeonthewater]

:-)

[Striper80]

I've found if I email pics that I've taken on my phone to myself, and resize them to medium, I can post them here without issue. You can still only post one at a time though.

Looking good.

[smokeonthewater]

I saved your pic to my phone, opened it, clicked edit, rotated it, and reposted it, all from my iphone....

[1224bret]

Thanks Smoke! And thank you Striper for the tip! I'll besure to try that next pic I post.