Va Beach v20 project

[Kracker Jack]

The stuff is amazing!!!! And super strong especially with multiple layup and you change the fiber direction. I built my entire boat with it it wrapped every curve on my boat.

[SkunkBoat]

do you use fairing compound over it before paint?

[Kracker Jack]

Originally Posted by SkunkBoat

do you use fairing compound over it before paint?

Yes it will need to be faired before primer and paint. I just barely bump grind the cloth then apply fairing compound as needed. Dont grind out to much you will lose strength. On this repair i had some thickened resin left so i slicked the repair with what i had left just to use it up.

[cterrebonne]

Originally Posted by Kracker Jack

Yes it will need to be faired before primer and paint. I just barely bump grind the cloth then apply fairing compound as needed. Dont grind out to much you will lose strength. On this repair i had some thickened resin left so i slicked the repair with what i had left just to use it up.

What I have done that works really well to not sand into the 1708 is to put some 1.5 CSM down as your last layer. Just so you have something that's easy to sand and you don't have to worry about cutting the fibers on the 1708.

[bradford]

Looking good and good advice all. You'll be happier with the transom at 25 inches.

[Striper80]

How many layers of glass did you lay on the outside of the repair to bring it even? I'm going to be raising the transom on my Grady to 25" as well.

[Kracker Jack]

The last layer of 1708 is the only layer thats meets the edge were i stopped grinding. Every other layer is progressive. Meaning i have 4 layers that build up the ply veneer then 2 final layers......the first of the final outside layer falls short from the grinding by like 4 inches....the last and final layer is the only one that meets the grind edge. It lets you progressively build up your thickness with out having all the thickness at the imediate edge. Hopefully that makes sense.

[Kracker Jack]

The trick to the clear bubble free 90 degree curves is to build up some thickened (fumed silica,cabosil) resin on the outside corners then lay your cloth down and wet it out like usual when you hit the corners with the bubble popper (roller) its like magic when spread the thickened resin under the cloth.

[Kracker Jack]

Did a little wiring on sunday. Fuse block and switch panel all wired. Just need to install lights and wire them up.